And thank you for your support to make this channel better. If you get stuck, I recommend a Mopar crank sensor. Other things I have done just as a side note are remove idle air controller, cleaned throttle body and butterfly valve with throttle body cleaner. I can let vehicle idle it will start to sputter then I unplug the camshaft sensor and the sputter goes away. Stock Grand Cherokee Tech. This feature is not available right now. This is geramicc85 signing out. Members List.
Error Code P is defined as CMP or CKP Signal Intermittent Condition. It refers to intermittent conditions in the CMP (camshaft position sensor) or the CKP. Repair Information for P Dodge code.
P DODGE CMP or CKP Signal Intermittent Condition Code Meaning, Causes, Symptoms, & Tech Notes
Learn what does P Dodge CMP or CKP Signal Intermittent Condition means, location and how to repair?. OBD II fault code P is a manufacturer specific code that is defined by car makers Ford, Lincoln, Mercury, Mazda, and Nissan as “Glow Plug.
I changed my crank sensor and it ran bad so I noticed no paper on the bottom of the sensor so I put a slice of tape on the sensor I guess it was to close after that I reinstalled it jeep ran great.
Rating is available when the video has been rented. P CODE 5.
Rough idle code p Jeep Cherokee Forum
Quote message in reply? We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.
I purchased and replaced the sensor and she started back up. So being new to the Cherokee I turned to this forum and found the common issue of the crankshaft position sensor.
Video: Diagnostic code p1391 Jeep grand cherokee crank no start p1391 and other similar code related.
You've already replaced the two sensors, so they shouldn't be a problem at. P Dodge | CMP or CKP Signal Intermittent Condition | The Engine Control Module (ECM) detected the actual Camshaft Position Sensor (CMP) position.
Loading more suggestions Now i am asking you for help.
Checked for vacuum leaks Idle and stalling issue. This is the freeze frame data that was stored.
Diagnostic code p1391
|Mark Forums Read.
I decided to change out the ecu engine computer.
The more I step on the gas, the worse the engine runs until it shuts off. ChrisFix 4, views. Thank you very much for watching.
Video: Diagnostic code p1391 P1391 The Follow Up